This is a good idea, but where to find a 100K, pull on / push off /
potentiometer ? I have seen them in some Heathkits kits but not in Spain.
73, Jaime EA6NB.
*-----Mensaje original-----
*De: owner-amps@contesting.com [mailto:owner-amps@contesting.com]En
*
*The SB220 should ALWAYS be started in the CW position to limit inrush
*current. NEVER start the SB220 in the SSB position, as it puts too much
*strain on components.
*
*The best idea yet was to take the pot, remove it, and replace it
*with a pull
*on / push off / potentiometer. This will allow you to still adjust the
*sensitivity of the meter as well as give you an operate standby
*switch, AND
*keep the amp looking stock.
*
*
*Hope this helps.
*
*
*Toll Free
*
*
*_________________________________________________________________
*Get your FREE download of MSN Explorer at http://explorer.msn.com
*
*
*--
*FAQ on WWW: http://www.contesting.com/FAQ/amps
*Submissions: amps@contesting.com
*Administrative requests: amps-REQUEST@contesting.com
*Problems: owner-amps@contesting.com
*
*
--
FAQ on WWW: http://www.contesting.com/FAQ/amps
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
|