ORIGINAL MESSAGE:
At 06:47 PM 5/23/2006, KR4DA wrote:
>I recieved the fan today.
>BUT the SPECS on the label say RPM 1100 and HP 1/500
>
>The web page says RPM 3000 and HP 1/200
*********** REPLY SEPARATOR ***********
RPMs are only part of the issue. The geometry of the fan is also
important, especially the angle of the blades as they cut through the
air. Low RPMs should have a high blade angle and vice versa.
The best way to ensure correct cooling is to measure the tube
temperature directly when running under full load. Use either a
non-contact thermometer (my choice) or color-changing paint or
crayon. Compare the reading with the tube manufacturer's specs and
you'll have your answer without worrying about RPM, pressure
difference, etc, etc. Tube temperature is the only thing that
matters. All those other measurements are just a way of getting you there.
Harbor Freight has a great non-contact thermometer for $39.95 + shipping.
http://www.harborfreight.com/cpi/ctaf/displayitem.taf?Itemnumber=91778
You can download the product manual from that site too. I got one and
it works great. I have found uses for it I never dreamed of when I
ordered it, such as measuring the temperature of my aquarium,
checking the refrigerator and freezer for proper operation, and a
dozen others. Sure, you could do those with a regular thermometer,
but this is so fast and easy it's all I use now.
The usual disclaimers apply; just a satisfied customer.
Bill, W6WRT
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|