Manny,
You can add a small amount of inductance between the coupling caps and Tune C
to drop it thus making it a L-Pi circuit.
Best,
Will
*********** REPLY SEPARATOR ***********
On 5/25/06 at 9:50 PM Manuel R. Alonso / KC4MNE wrote:
>Hello
>
>Would it be feasable to build a 4 tube amplifier using the 4cx800 russian
>tubes.
>
>I calculated a plate impeadance of about 490 ohms, using (2600V 3.0 amp
>supply)
>
>However for a Pi output I am looking at a c1 value of about 100 pf at
>29MHZ and each tube has 51pf of capacitance already, if added together
>thats over 200pf. How is this obstacle corrected?
>
>Manny
>
>KC4MNE
>
>_______________________________________________
>Amps mailing list
>Amps@contesting.com
>http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|