Hello all,
I recieved the cold plate (liquid cooling plate that attaches to the heat
spreader) in for the linear project I'm working on. It has 1/8 inch copper
tubing coming out of it for a couple inches and is designed to have more copper
brake line soldered/brazed to it. Is there a tool that I could use to expand
out the brake line a little so it will slip over the other brake line and allow
a good mechanical connection before soldering?
73,
Mike
---------------------------------
Talk is cheap. Use Yahoo! Messenger to make PC-to-Phone calls. Great rates
starting at 1¢/min.
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|