In a message dated 8/11/2006 1:25:35 PM Eastern Standard Time,
ke6cvh@yahoo.com writes:
I was wondering if there is a "next size larger tubing" that will fit
over it like telescoping aluminum tubing for antennas. If there is that would
be
the easiest approach for sure. Possibly, if there is not an easier next size
up of tubing I could get a small bit of copper and use a drill press to drill
it out with the right bit then slip it over and solder. I would have to heat
it up before sliding it over to try to keep the heat stress off the cold plate.
73,
Mike
Small Parts Inc. has an assortment of small sizes of telescoping copper
tubing. They have a larger selection of telescoping brass tubing in 1/32" steps
if
that would work for your purpose for an adapter joint between different sizes
of copper tubing. 73 Todd WD4NGG
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|