Hello Mike:
Try Allen Bond here: http://mgs4u.com/relay.htm
or they are available from Gigavac here:
http://www.gigavac.com/products/relays/ham/index.htm
The GH-1 uses the same mounting hardware from Gigavac.
73 and Happy DXing,
Mike
W2AJI
----- Original Message -----
From: "Mike" <k4gmh@arrl.net>
To: <amps@contesting.com>
Sent: Thursday, September 14, 2006 11:25 PM
Subject: [Amps] Kilovac HC-2 Mounting Nut
> Hello,
>
> Need a couple of the mounting nuts for a pair of Kilovac HC-2. Tried
> M14x1.5mm nuts, but none work on the HC-2. The threads on the
> M14x1.5 nuts I could find were too coarse for the fine threads on the
> relay. The spec sheet identifies the threads as M14x1.5-6g. Not
> sure what the "-6g" means; something to do with "fine" thread?
>
> 73,
> Mike, K4GMH
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|