If I recall correctly, the M14x1.5-6g is the Metric fine thread used on
pressure gauges
and similar hydraulic/pneumatic hardware in Europe.
Can you measure the actual dimensions and pitch of the threads on your relay?
With this description it might be possible to find the proper nut.
The standard M14 coarse thread has a 2 mm pitch.
73/
Karl-Arne
SM0AOM
----- Original Message -----
From: "Mike" <k4gmh@arrl.net>
To: <amps@contesting.com>
Sent: Friday, September 15, 2006 5:25 AM
Subject: [Amps] Kilovac HC-2 Mounting Nut
> Hello,
>
> Need a couple of the mounting nuts for a pair of Kilovac HC-2. Tried
> M14x1.5mm nuts, but none work on the HC-2. The threads on the
> M14x1.5 nuts I could find were too coarse for the fine threads on the
> relay. The spec sheet identifies the threads as M14x1.5-6g. Not
> sure what the "-6g" means; something to do with "fine" thread?
>
> 73,
> Mike, K4GMH
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
> --
> No virus found in this incoming message.
> Checked by AVG Free Edition.
> Version: 7.1.405 / Virus Database: 268.12.3/446 - Release Date: 2006-09-12
>
>
--
No virus found in this outgoing message.
Checked by AVG Free Edition.
Version: 7.1.405 / Virus Database: 268.12.4/448 - Release Date: 2006-09-14
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|