I'm sure John is correct about both the risks of resoldering and the ideal
solution, but what to do if you have tubes that have already failed from this
cause?
Using some of Rich Measures' silver solder and packing the area around the
glass seal with wet paper towels, I have successfully repaired several tubes.
Last time around, operating on the theory that the spring clips on the filament
pins might have lost their temper, I swapped them for those on grid pins from
the same socket. I also made a point to polish the inside of the socket
contacts and the filament pins in the hope of reducing the resistive heating at
that point. These fixes have so far been effective in intense CW and SSB
contest use for several years.
73, Pete N4ZR
-------------- Original message --------------
From: "John E. Cleeve" <g3jvc@jcleeve.idps.co.uk>
> I would advise caution in resoldering the sleeved pins of the 3-500 et al
> tubes, for the Eimac spec. and the late Bill Orr, warned that the melting
> point of the solder used, could be very close to the temperature which
> would destroy the glass to metal seal of the filament pins..........more
> effective electrical contact, between the tube filament pin sleeves and
> sockets, with more effective directed forced air cooling of the tube base
> sockets are the routes to follow.....but this has all be said
> before.....regards, John G3JVC.
>
>
> ----- Original Message -----
> From: "Steve Thompson"
> To:
> Sent: Thursday, February 08, 2007 12:15 PM
> Subject: Re: [Amps] 3-500z - intermittent filament
>
>
> >
> >
> > terry@g4amt.com wrote:
> >
> >> The pins are riveted over on the tube side of the `former` so they cannot
> >> (?) be removed; they are of `split` construction. The only way I could
> >> re-solder them was to use a solder sucker to extract the old solder - put
> >> a
> >> couple of drips of flux in the hole and re-solder with silver solder;
> >> heating the pin with a mini-blowlamp ...
> >
> > A question as to what should be used here? There's 'silver solder' as
> > used with a torch for brazing. There's also standard pcb solders with
> > added silver content to give them a lower melting point than straight
> > tin/lead.
> >
> > Steve
> > _______________________________________________
> > Amps mailing list
> > Amps@contesting.com
> > http://lists.contesting.com/mailman/listinfo/amps
> >
> > --
> > This email has been verified as Virus free
> > Virus Protection and more available at http://www.plus.net
> >
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|