Lou:
Thanks. I will give it a try.
73
Dave K3FT
On 10/29/07, Gudguyham@aol.com <Gudguyham@aol.com> wrote:
>
> Switch amplifier meter to power output. Send a carrier of about 20 watts
> from exciter to the amp. Tune for maximum output with both load and tune.
> Send another 20 watts from exciter to amp, peak load and tune for maximum
> output. Send another 20 watts and tune for maximum. Do this until the
> rated plate current is reached or the stated output is reached. It is
> pretty simple. You could at the end advance the load until power just drops
> off, that will ensure good IMD. 73 Lou
>
>
>
> ------------------------------
> See what's new at AOL.com <http://www.aol.com?NCID=AOLCMP00300000001170>and
> Make
> AOL Your Homepage<http://www.aol.com/mksplash.adp?NCID=AOLCMP00300000001169>
> .
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|