Switch amplifier meter to power output. Send a carrier of about 20 watts
from exciter to the amp. Tune for maximum output with both load and tune.
Send another 20 watts from exciter to amp, peak load and tune for maximum
output. Send another 20 watts and tune for maximum. Do this until the rated
plate
current is reached or the stated output is reached. It is pretty simple.
You could at the end advance the load until power just drops off, that will
ensure good IMD. 73 Lou
************************************** See what's new at http://www.aol.com
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|