Amps
[Top] [All Lists]

Re: [Amps] plate bypass capacitor

To: "'Carl'" <km1h@jeremy.mv.com>, <dezrat1242@yahoo.com>, <amps@contesting.com>
Subject: Re: [Amps] plate bypass capacitor
From: "Gary Schafer" <garyschafer@comcast.net>
Date: Mon, 10 Aug 2009 14:40:18 -0500
List-post: <amps@contesting.com">mailto:amps@contesting.com>
I have a TMC amp with a pair of 3-400Z tubes 2-18 MHz with a 2.5 or 3.5
millihenry plate choke. They get away with that because it doesn't need to
go above 18 MHz. the first series resonance on the choke is around 24 MHz if
I remember right.

73
Gary  K4FMX

> -----Original Message-----
> From: amps-bounces@contesting.com [mailto:amps-bounces@contesting.com] On
> Behalf Of Carl
> Sent: Monday, August 10, 2009 2:34 PM
> To: dezrat1242@yahoo.com; amps@contesting.com
> Subject: Re: [Amps] plate bypass capacitor
> 
> Then look at the 2-40KW 2-22 or 30mc  commercial amps from Collins, Press
> Wireless, Bendix, WE, Harris, etc.
> 
> Carl
> KM1H
> 
> 
> ----- Original Message -----
> From: "Bill, W6WRT" <dezrat1242@yahoo.com>
> To: <amps@contesting.com>
> Sent: Monday, August 10, 2009 3:19 PM
> Subject: Re: [Amps] plate bypass capacitor
> 
> 
> > ORIGINAL MESSAGE:
> >
> > On Mon, 10 Aug 2009 11:19:57 -0700 (GMT-07:00), Colin Lamb
> > <k7fm@teleport.com>
> > wrote:
> >
> >> As I recall, almost all of the 6146 rigs, along with the novice
> >> transmitters, use 2.5 mh rf chokes.  And, of course, there is the ARC-
> 5.
> >
> > REPLY:
> >
> > I keep forgetting about you QRP guys. I was talking REAL amplifiers.  :-
> )
> >
> > 73, Bill W6WRT
> > _______________________________________________
> > Amps mailing list
> > Amps@contesting.com
> > http://lists.contesting.com/mailman/listinfo/amps
> 
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps


_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>