Ron Youvan wrote:
>> MSDC Klystrons ran around ten feet @ 32KV applied.
>
> If they use Teflon tubing a foot might be sufficient. Different brands
> are cooled differently so
> it may depend on the arrangement.
Perhaps I have mis-understood what you are saying, in which case I apologise.
Surely it is conductivity of the water that matters, not of the tubing. Most
plastics have a hell of a lot lower conductivity than water, so I would think
it
is pretty irrelevant what plastic is used from a point of conductivity.
Dave
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|