Amps
[Top] [All Lists]

Re: [Amps] lcr meter

To: dezrat1242@yahoo.com
Subject: Re: [Amps] lcr meter
From: Roger <sub1@rogerhalstead.com>
Date: Thu, 01 Apr 2010 10:54:51 -0400
List-post: <amps@contesting.com">mailto:amps@contesting.com>

Bill, W6WRT wrote:
> ORIGINAL MESSAGE:
>
> On Thu, 1 Apr 2010 06:56:18 -0700, "Jim Thomson" <Jim.thom@telus.net>
> wrote:
>
>   
>> ## exactly what it sez... the mfj 259 is a glorified swr meter.  Don't even
>> think abt using it to set taps on a tank coil,
>>     
>
> REPLY:
>
> I have to disagree on not using it to set taps on a tank coil. When
> connected in reverse, i.e. connecting it to the output of a pi-net,
> with a non-inductive resistor of the appropriate value from plate to
> ground, it does an excellent job of helping you find the right tap. 
>
> For all the other purposes that MJF claims (grid-dipper, etc, etc) I
> agree it's junk. 
>   

It's one of the greatest gadgets for setting an antenna tuner you'll 
find.  Hooked in the line with a switch to select either the input to 
the tuner, or 259 you can adjust the tuner of 52 ohms X=0, tune the amp 
into a 50 ohm dummy load, switch amp to the tuner and you are set to go 
without ever putting a signal on the air.

73

Roger (K8RI)
> 73, Bill W6WRT
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>   
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>