ORIGINAL MESSAGE:
On Sat, 3 Apr 2010 06:02:15 -0700, "Jim Thomson" <Jim.thom@telus.net>
wrote:
>
>## I found that if I measured the taps with the b+K 875.. and tapped the
>coil
>using the spread sheet results..... everything came out just fine. When the
>Tune cap
>was checked [ after resonating the tune + load caps.. with mfj on the output]
> after
>the fact, it was dead on VS the spreadsheet. [ or extremely close]
REPLY:
Good enough.
73, Bill W6WRT
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|