Amps
[Top] [All Lists]

Re: [Amps] Warm up and on time question...

To: <amps@contesting.com>
Subject: Re: [Amps] Warm up and on time question...
From: "Hsu" <hsu4qro@gmail.com>
Date: Wed, 14 Dec 2011 01:32:35 +0800
List-post: <amps@contesting.com">mailto:amps@contesting.com>
The direct heat filament/cathode  only needs few secondsv to work.
  If power supply of filment without inrush current limiter or  soft start,
you'd better keep it turn on  in  half hour.
a good idea if you add half volt of  filament when stand  by. When you
operate, add full voltage.But it needs modify the amps's filament supply.

-----原始邮件----- 
From: Dave Cole
Sent: Tuesday, December 13, 2011 11:30 PM
To: amps@contesting.com
Subject: [Amps] Warm up and on time question...

Hello,

I have an AL-82, my habit is to turn it on, allow it to warm for about 5
minutes prior to use, use the amp, then turn it back off.  Sometimes I
find that I will be using the amp again within 10 or 15 minutes, maybe
30 minutes.  Is it better to leave it on for the half hour, or turn it
off then re power it 30 minutes later.

Does this cause any issues over the long term?  Should I just leave it
on for the half hour?  Worried about repeated heating and cooling of the
tubes.

Dave
NK7Z

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps 

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
<Prev in Thread] Current Thread [Next in Thread>