Defective radios is probably the most of it. Slow ALC is probably the
rest... or rf controlled electronic bias that keep the amplifier cut off
between dits.
73
Jim W7RY
--------------------------------------------------
From: "richard courtway" <courtway@syix.com>
Sent: Thursday, December 29, 2011 11:09 AM
To: <Amps@contesting.com>
Subject: [Amps] IMD
> Have been enjoying and learning from the discussions concerning IMD
> problems with SSB signals and their causes.
>
> Personally am a cw operator - and hear quit a few very wide and
> splattering cw signals . Thinking that most of this is caused by
> operators trying to get a kw out of a 800 watt rig. Overdriving - etc.
>
> Am approaching the time when I will have my first amp on line - and
> wondering if any of you would care to comment on the causes of such
> lousy sounding cw signals.
>
> Thankee - and HNY to you all.
>
> de Dick / aka N7RC
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|