Ive outlined the steps several times on here under gettering, see the archives.
Carl
KM1H
----- Original Message -----
From: Robert Groh
To: Carl ; amps@contesting.com
Sent: Sunday, March 18, 2012 11:38 AM
Subject: Re: [Amps] April QST article on RF power tube test stand
Carl,
I would be very interested in your ideas on what should be added. My opinion
was also that it was a bit limited (keeping in mind my absolute beginner status
in high power amps) and could stand a few additions such as easy provision for
running lower plate voltage for gettering, some way to test emission, etc.
Also still needs some way to hipot the tube but I guess that is best handled
with a separate hipot test setup.
In any event, I would be most eager to hear your ideas.
73
Bob, WA2CKY
------------------------------------------------------------------------------
From: Carl <km1h@jeremy.mv.com>
To: Rob Atkinson <ranchorobbo@gmail.com>; amps@contesting.com
Sent: Sun, March 18, 2012 10:30:24 AM
Subject: Re: [Amps] April QST article on RF power tube test stand
Its a mostly waste of time as built. A little more work and it could be
useful to do emissions tests as well as proper (safe) gettering.
Carl
KM1H
------------------------------------------------------------------------------
No virus found in this message.
Checked by AVG - www.avg.com
Version: 10.0.1424 / Virus Database: 2113/4878 - Release Date: 03/18/12
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|