Sounds to me like there are two possibilities, One, your input network
is miswired or not switching into the 80m position properly, and
second is the same for your tank circuit. There isn't much else to go
wrong. I'm betting it's the tank circuit.
73,
Jim w8zr
Sent from my iPhone
On Jan 27, 2013, at 5:31 PM, Dick NY1E <dick@ny1e.com> wrote:
> I have a homebrew 8877 that has been working fine for 12 years on 160 and 40
> thru 10, but I never had an 80M antenna. I finally got one up and the amp
> wont load on 80. It is stable, draws full current, but puts out less than the
> input, I've played around adding and removing padders to the plate and load
> caps. There is no tuned input.Any ideas???Thanks, Dick NY1E
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|