I'd suspect a RF plate choke which is resonant on 80. Try a different plate
choke.
Lee, w0vt
----- Original Message -----
ORIGINAL MESSAGE:
On Sat, 26 Jan 2013 15:18:40 -0800 (PST), NY1E wrote:
>
>I have a homebrew 8877 that has been working fine for 12 years on 160 and 40
>thru 10, but I never had an 80M antenna. I finally got one up and the amp wont
>load on 80. It is stable, draws full current, but puts out less than the
>input, I've played around adding and removing padders to the plate and load
>caps. There is no tuned input.Any ideas???Thanks, Dick NY1E
REPLY:
Does it load correctly into a dummy load?
Bill, W6WRT
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|