Amps
[Top] [All Lists]

Re: [Amps] Advice needed for SS amp

To: Amps <amps@contesting.com>
Subject: Re: [Amps] Advice needed for SS amp
From: Bill Turner <dezrat1242@yahoo.com>
Date: Wed, 05 Jun 2013 10:35:31 -0700
List-post: <amps@contesting.com">mailto:amps@contesting.com>
ORIGINAL MESSAGE:          (may be snipped)

On Wed, 5 Jun 2013 09:48:32 -0700, Mike wrote:

>would it not be easyer to use a supply that delivers a +200V(to D1) and 
>-200V(to S2) with pin S1D1 & S3D4 at case/supply ground ?

REPLY:

Did you mean S1D2 instead of S1D1? 

I don't think you can do what you ask because I think that S1D2 & S3D4 are
where you take the output from, i.e. where the output transformer is
connected. 

Not absolutely sure on this, still in learning mode bout this H-bridge
configuration. 

73, Bill W6WRT
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>