Is this into a dummy load?
Is the amp grounded?
Carl
KM1H
----- Original Message -----
From: "Jim Barber" <audioguy@q.com>
To: <Amps@contesting.com>
Sent: Thursday, October 17, 2013 12:59 AM
Subject: [Amps] Alpha 76A - 120hz hum on 160m only
After replacing the filter caps and equalizing resistors, I fired up
the 76A today on 40m and had a couple of nice contacts. The 120hz hum
problem *appeared* to be gone. The spectrum analyzer showed a nice sharp
clean carrier, with no "funnies" in the sidebands or for a few mHZ
either side.
And then I tuned up on 160m. 120hz hum like crazy on a carrier, hum
distortion on SSB. Unusable.
Tuned up on 75m, clean as a whistle.
So - it hums like crazy on 160m, but not on the other bands.
Plate choke and/or bypass caps? It loads up fine on 160, just hums like
crazy.
Ideas? (other than exorcism)
Thanks,
Jim N7CXI
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 10.0.1432 / Virus Database: 3222/6257 - Release Date: 10/17/13
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|