Hi Doug,
I had a similar problem with an HF-1250. There is a solid state relay
(I think there are two, been a while) mounted on the right hand side of
the power supply compartment and it developed problems.
73, George
W2GS
On 11/18/2013 10:57 PM, doug ferguson wrote:
Hi,
My HF-1250 just went out. It was working fine and then the lights and fan
started flickering for about 5 seconds and then the whole thing went dark.
No smells or sounds and no apparent burn marks that I can see. The power
supply components involve taking the entire amp apart to check so was hoping
someone can give me some other ideas before I have to do that.
The fuses are both good; wall power, the front power switch and interlock
switch are good.
Not sure if these amps have thermal fuses in the transformer? The schematic
doesn't show
one although they usually don't.
Would a shorted 3cx800a7 cause this? Like I said, it went slowly and quietly -
no bangs,
pops or smells or broken components that I can see. It just won't turn on.
Any help on where to start would be greatly appreciated.
73,
Doug - N7NM
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|