| To: | <amps@contesting.com> |
|---|---|
| Subject: | Re: [Amps] Building an Amp 101 |
| From: | "Peter Voelpel" <dj7ww@t-online.de> |
| Date: | Sat, 18 Jan 2014 20:05:52 +0100 |
| List-post: | <amps@contesting.com">mailto:amps@contesting.com> |
Don´t you think it depends on anode voltage and output impedance of the Tube(s)used? The switch is adequate when used in a 1500W amp on low to medium anode voltage. It will certainly arc if you use a 8281 at 1500W out with 10KV anode voltage. 73 Peter -----Original Message----- From: Amps [mailto:amps-bounces@contesting.com] On Behalf Of Bill Turner I design conservatively. Anyone who thinks that switch is adequate probably rides a motorcycle at full freeway speeds in heave traffic and thinks they are perfectly safe _______________________________________________ Amps mailing list Amps@contesting.com http://lists.contesting.com/mailman/listinfo/amps |
| Previous by Date: | Re: [Amps] Building an Amp 101, Carl |
|---|---|
| Next by Date: | Re: [Amps] Building an Amp 101, Roger (K8RI) |
| Previous by Thread: | Re: [Amps] Building an Amp 101, Carl |
| Next by Thread: | Re: [Amps] Building an Amp 101, Bill Turner |
| Indexes: | [Date] [Thread] [Top] [All Lists] |