No need to use #12. Smaller wire = more compact. A shorter piece of #16 (or
maybe even #18), would do fine.
Depends on the current.
73, Mike
www.w0btu.com
On Sat, Dec 10, 2016 at 5:58 PM, kenneth Johnson <wa6rtp@hotmail.com> wrote:
> I used # 12 wire …total of 24 inches long wound in a two inch coil placed
> in each filament lead .
> this droped the voltage on my henry 2k-3 filaments into specifation.
> your problem is finding enough room to get the coil in there. at any rate
> …a length of wire is the way to go.
>
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|