Amps
[Top] [All Lists]

Re: [Amps] HIGH FILAMENT VOLTAGE

To: "amps@contesting.com" <Amps@contesting.com>
Subject: Re: [Amps] HIGH FILAMENT VOLTAGE
From: Richard Solomon <dickw1ksz@gmail.com>
Date: Sat, 10 Dec 2016 17:34:11 -0700
List-post: <amps@contesting.com">mailto:amps@contesting.com>
You can also use Nichrome wire from
an old toaster or such.

BUT, before you go through this, make
sure the meter you use to measure the
Filament Voltage is accurate. Try making
the measurement with 2 or 3 other meters.

73 es HH, Dick, W1KSZ

On Sat, Dec 10, 2016 at 4:58 PM, kenneth Johnson <wa6rtp@hotmail.com> wrote:

> I used # 12 wire …total of 24 inches long  wound in a two inch coil placed
> in each filament lead .
> this  droped  the voltage on my henry 2k-3  filaments into specifation.
> your problem is finding enough room to get the coil in there.  at any rate
> …a length of wire is the way to go.
> Sent from Windows Mail
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
<Prev in Thread] Current Thread [Next in Thread>