And the meter should be specified as measuring "true rms".
Vic 4X6GP
> On 11 Dec 2016, at 02:34, Richard Solomon <dickw1ksz@gmail.com> wrote:
>
> You can also use Nichrome wire from
> an old toaster or such.
>
> BUT, before you go through this, make
> sure the meter you use to measure the
> Filament Voltage is accurate. Try making
> the measurement with 2 or 3 other meters.
>
> 73 es HH, Dick, W1KSZ
>
>> On Sat, Dec 10, 2016 at 4:58 PM, kenneth Johnson <wa6rtp@hotmail.com> wrote:
>>
>> I used # 12 wire …total of 24 inches long wound in a two inch coil placed
>> in each filament lead .
>> this droped the voltage on my henry 2k-3 filaments into specifation.
>> your problem is finding enough room to get the coil in there. at any rate
>> …a length of wire is the way to go.
>> Sent from Windows Mail
>>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|