To: | paul@paulbaldock.com, michelle_melt@windstream.net, amps@contesting.com |
---|---|
Subject: | Re: [Amps] Drake L4B to 6 Meters Help |
From: | gudguyham--- via Amps <amps@contesting.com> |
Reply-to: | gudguyham@aol.com |
Date: | Tue, 13 Dec 2016 02:22:55 -0500 |
List-post: | <amps@contesting.com">mailto:amps@contesting.com> |
That's what I've been saying all along. Sent from AOL Mobile Mail -----Original Message----- From: Paul Baldock <paul@paulbaldock.com> To: Michelle <michelle_melt@windstream.net>; amps <amps@contesting.com> Sent: Tue, Dec 13, 2016 12:26 AM Subject: Re: [Amps] Drake L4B to 6 Meters Help Michelle Did you say that you are running the 2 tubes a zero bias and have about 100mA idle current. I think it should be more like 200mA in the SSB position. This would suggest that either your high voltage is low, or that one tube is not working/connected. One tube would be a good reason for only getting 600W PEP. - Paul _______________________________________________ Amps mailing list <a href="mailto:Amps@contesting.com">Amps@contesting.com</a> <a href="http://lists.contesting.com/mailman/listinfo/amps" target="_blank">http://lists.contesting.com/mailman/listinfo/amps</a> _______________________________________________ Amps mailing list Amps@contesting.com http://lists.contesting.com/mailman/listinfo/amps |
Previous by Date: | Re: [Amps] Drake L4B to 6 Meters Help, gudguyham--- via Amps |
---|---|
Next by Date: | Re: [Amps] MOSFET amp filtering - was: auto-tune, Jim Brown |
Previous by Thread: | Re: [Amps] Drake L4B to 6 Meters Help, Joe |
Next by Thread: | Re: [Amps] Drake L4B to 6 Meters Help, gudguyham--- via Amps |
Indexes: | [Date] [Thread] [Top] [All Lists] |