Hi Ron,
I like the idea of putting the choke in the return lead. But the way the
return floats a bit above ground for metering makes me uncertain exactly
where to wire in choke.
- between bridge and resistors to ground, or...
- between resistors to ground and filter capacitor returns
thanks,
jeff, wa1hco
On Thu, Sep 26, 2019 at 10:59 PM Ron <ka4inm@gmail.com> wrote:
> Jeff wa1hco millar wrote:
>
> > Hello wise ones...
>
> > Bought a nice 3K-A at a flea market and made one SSB contact. On the
> > second contact it tripped off on HV overcurrent. After some debugging,
> the
> > Plate choke is leaky to ground at HV but open with an Ohm meter.
> > Can I just put the choke up on insulated standoffs?
>
> > Any other suggestions?
>
> It is a pleasure to be helpful.
>
> The CURE is to put it in the ground side of the circuit, typically
> where the rectifier or the grounded side of the transformer goes to
> ground.
>
> --
> Ron KA4INM - Understanding is much better than
> knowing how.
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|