CQ-Contest
[Top] [All Lists]

[CQ-Contest] Re: Re: Yaesu FT1000mp Mark V Key Clicks

Subject: [CQ-Contest] Re: Re: Yaesu FT1000mp Mark V Key Clicks
From: sm2ekm@telia.com (Jan Erik Holm)
Date: Sat Dec 14 07:28:39 2002
What i wrote below that I adjusted components to
get a steeper rise isn´t compleatly thrue.
As someone pointed out it´s not the rise time
thats to short but the fall time.
It´s absolutley correct since almost all of these
radios click on the break side and not on the make.
Otherwise, thank´s for the comments

Merry Christmas Jim SM2EKM

PS: Tonight I had a strange dream. I dreamt that all
my towers fell down in a wind storm. It was so strange
since the Yagi elements did brek in like 1000 pieces
but it didn´t break any of the Yagi booms. I must be
ready for the funny farm I think.
-------------------------------------------------------

Marijan Miletic, S56A wrote:
> YAESU is notorious for missing a single resistor at the right place!
> Speaker clicks after headphones are unplugged could be solved with a
> parallel 100 Ohms.   Poor CW shaping could be solved by adding 10 kOhms
> resistor in the base of Q1019 2SC2812 NPN keying transistor.  W8JI used
> additional capacitance on C1216 and redundant network on C2148.  He was
> warned that the result would be too soft but one doesn't notice that on 160
> m DX...
> 
> 73 de Mario, S56A, N1YU
> 
> I did notice the same, too soft. I did change
> some component value to get a steeper rise
> however I don´t remember what values I did use,
> sorry about that, it works good now.
> If you hear me on CW you might comment to me how
> you find the keying.
> 
> 73 Jim SM2EKM
> 
> PS: I use a 1000D
> ----------------------------------------------------
>



<Prev in Thread] Current Thread [Next in Thread>