I am finding that when I do that, I can no longer access the RG through the
configurator.
Jim
----- Original Message -----
From: "Tony " <tonylist@wwwbiz.com>
To: <karlnet@WISPNotes.com>
Sent: Saturday, June 15, 2002 11:22 AM
Subject: RE: [Karlnet] Outgoing NAT config
> Jim
>
> The pubic address should be set to the public address you want NAT to
> translate to. If you only have one public then yes.
>
> Sincerely
> Tony Morella
> Demarc Technology Group
> Office: 908-996-7995
> Cell: 908-246-9170
> Fax: 908-847-0202
> email: tony@demarctech.com
> http://www.demarctech.com
> Wireless Solution Provider
>
>
> -----Original Message-----
> From: karlnet-admin@WISPNotes.com [mailto:karlnet-admin@WISPNotes.com]
> On Behalf Of Jim
> Sent: Saturday, June 15, 2002 9:01 AM
> To: karlnet@WISPNotes.com
> Subject: [Karlnet] Outgoing NAT config
>
>
> In outgoing NAT config, should the Public Address and Mask be set to the
> same as the address assigned to the radio?
>
> Jim
>
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
|