Hello Nate,
The WPII are picky about the order and timing of pressing the reset
and reload buttons.
Press the reset and when the "PC card B" LED turn orange, quite quick,
rrelease the reset and press the reload untill the power led is
oraange.
good luck
Rod
Monday, September 16, 2002, 6:17:43 PM, you wrote:
NM> Has anyone else had any problems flashing the WP-II E??
NM> I just tried to flash 2 of these and they both act the same way....
NM> You can read them with the configev program.
NM> Get your license, Open config file, select the .bin file.
NM> Scan for the radio. Change the IP of the WPIIE to a IP in my subnet.
NM> Upload the software.
NM> Let the AP reboot and then your hosed...
NM> You can never scan it and you never get another network connection to it...
NM> I tried doing a forced reload as described in the pdf file and I can't ever
NM> get it into base boot mode... The power led always goes to green. And no
NM> network connection.
NM> Can someone shed some light on this problem?
NM> TIA
NM> Nate
NM> _______________________________________________
NM> Karlnet mailing list
NM> Karlnet@WISPNotes.com
NM> http://lists.wispnotes.com/mailman/listinfo/karlnet
--
Best regards,
A. mailto:things@mail.chiriqui.com
|