That is how I always flash my radios... :-)
Nate
> Try plugging your computer directly into it with an x-over cable.
>
> Nate McLain wrote:
>
> > Has anyone else had any problems flashing the WP-II E??
> > I just tried to flash 2 of these and they both act the same way....
> >
> > You can read them with the configev program.
> > Get your license, Open config file, select the .bin file.
> > Scan for the radio. Change the IP of the WPIIE to a IP in my subnet.
> > Upload the software.
> >
> > Let the AP reboot and then your hosed...
> > You can never scan it and you never get another network connection to
it...
> >
> > I tried doing a forced reload as described in the pdf file and I can't
ever
> > get it into base boot mode... The power led always goes to green. And no
> > network connection.
> >
> > Can someone shed some light on this problem?
> >
> > TIA
> >
> > Nate
> >
> > _______________________________________________
> > Karlnet mailing list
> > Karlnet@WISPNotes.com
> > http://lists.wispnotes.com/mailman/listinfo/karlnet
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
--
Open WebMail Project (http://openwebmail.org)
|