Karlnet
[Top] [All Lists]

Re: [Karlnet] WavePoint - II E ???

To: karlnet@WISPNotes.com
Subject: Re: [Karlnet] WavePoint - II E ???
From: "nate" <nate@www.ctrail.net>
Reply-to: karlnet@WISPNotes.com
Date: Mon, 16 Sep 2002 20:48:04 -0500
List-post: <mailto:karlnet@WISPNotes.com>
I will give it a try.
I wouldn't think it would be that picky... 
But I did try lots of different ways and timing when i was trying to get it 
into base boot mode.

I will give this one a try as well.

Nate


> Hello Nate,
> 
> The WPII are picky about the order and timing of pressing the reset
> and reload buttons.
> 
> Press the reset and when the "PC card B" LED turn orange, quite 
> quick, rrelease the reset and press the reload untill the power led 
> is oraange.
> 
> good luck
> 
> Rod
> 
> Monday, September 16, 2002, 6:17:43 PM, you wrote:
> 
> NM> Has anyone else had any problems flashing the WP-II E??
> NM> I just tried to flash 2 of these and they both act the same way....
> 
> NM> You can read them with the configev program.
> NM> Get your license, Open config file, select the .bin file.
> NM> Scan for the radio. Change the IP of the WPIIE to a IP in my subnet.
> NM> Upload the software.
> 
> NM> Let the AP reboot and then your hosed...
> NM> You can never scan it and you never get another network 
> connection to it...
> 
> NM> I tried doing a forced reload as described in the pdf file and I 
> can't ever NM> get it into base boot mode... The power led always 
> goes to green. And no NM> network connection.
> 
> NM> Can someone shed some light on this problem?
> 
> NM> TIA
> 
> NM> Nate
> 
> NM> _______________________________________________
> NM> Karlnet mailing list
> NM> Karlnet@WISPNotes.com
> NM> http://lists.wispnotes.com/mailman/listinfo/karlnet
> 
> -- 
> Best regards,
>  A.                            mailto:things@mail.chiriqui.com
> 
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet


--
Open WebMail Project (http://openwebmail.org)


<Prev in Thread] Current Thread [Next in Thread>