make sure that, in the .bin file before uploading, you've actually setup the
interfaces to Ethernet & Wireless
-Charles
-----Original Message-----
From: karlnet-admin@WISPNotes.com [mailto:karlnet-admin@WISPNotes.com]On
Behalf Of Nate McLain
Sent: Tuesday, October 01, 2002 1:34 PM
To: karlnet@WISPNotes.com
Subject: [Karlnet] AP-1000 Goofyness
I have a AP-1000 that doesn't work right.
I can see it via a scan of the configev program.
Once I flashed the radio with the proper bin file and license the ethernet
port NEVER comes back up... You never get a connect to it with a crossover
cable.
But I can access it via a wireless connection. The ethernet port is enabled
but still no go. I have verified that the crossover cable it good..
Has anyone else seen this problem??
I can't figure out why the ethernet port is just dead.
Nate
_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet
|