Karlnet
[Top] [All Lists]

RE: [Karlnet] AP-1000 Goofyness

To: <karlnet@WISPNotes.com>
Subject: RE: [Karlnet] AP-1000 Goofyness
From: "Charles Chia Sheng Wu" <cwu@cwlab.net>
Reply-to: karlnet@WISPNotes.com
Date: Tue, 1 Oct 2002 14:27:40 -0500
List-post: <mailto:karlnet@WISPNotes.com>
don't change your IP addres, click on change IP to change the AP to an IP on
your subnet, and everything should be fine

if in doubt, feel free to give me a call - 773-667-4585

-Charles

-----Original Message-----
From: karlnet-admin@WISPNotes.com [mailto:karlnet-admin@WISPNotes.com]On
Behalf Of Nate McLain
Sent: Tuesday, October 01, 2002 2:12 PM
To: karlnet@WISPNotes.com
Subject: RE: [Karlnet] AP-1000 Goofyness


Before I flash the AP it has the default Orinoco IP. 153.x.x.x
I connect via a croosover cable, flash the AP, then it resets itself.
Then I never get a ethernet connection to it. When I connect via a wireless
card in my laptop it has the Karlnet IP of 198.17.74.254. So I gave myself a
198.17.74.100 IP in the same subnet and still no go with the ethernet
cable... This is really weird...
I can always put it back into base boot mode. And it has the 153 IP again.

Nate

-----Original Message-----
From: karlnet-admin@WISPNotes.com [mailto:karlnet-admin@WISPNotes.com]On
Behalf Of Roger Boggs
Sent: Tuesday, October 01, 2002 1:52 PM
To: karlnet@WISPNotes.com
Subject: Re: [Karlnet] AP-1000 Goofyness


Yes, but is the default IP address of the KarlNet Bridge firmware the same
as
the default IP address of the Orinoco AP1000 AP?

Assume NOTHING.  If the default addresses are different  before and after
firmware flash, then it would make sense that you would have to reconfigure
your configuration computer to the new address/subnet before you could
continue.

But then again, maybe not.....


At 01:34 PM 10/1/02 -0500, you wrote:
>I have a AP-1000 that doesn't work right.
>I can see it via a scan of the configev program.
>Once I flashed the radio with the proper bin file and license the ethernet
>port NEVER comes back up... You never get a connect to it with a crossover
>cable.
>But I can access it via a wireless connection. The ethernet port is enabled
>but still no go. I have verified that the crossover cable it good..
>
>Has anyone else seen this problem??
>I can't figure out why the ethernet port is just dead.
>
>Nate

Roger Boggs

_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet



_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet


<Prev in Thread] Current Thread [Next in Thread>