I experienced it when I set the ethernet to Auto Speed Auto Duplex on a
goofy switch. I went back to 10mbit half and it worked fine.
----- Original Message -----
From: "Nate McLain" <nate@ctrail.net>
To: <karlnet@WISPNotes.com>
Sent: Tuesday, October 01, 2002 1:34 PM
Subject: [Karlnet] AP-1000 Goofyness
> I have a AP-1000 that doesn't work right.
> I can see it via a scan of the configev program.
> Once I flashed the radio with the proper bin file and license the ethernet
> port NEVER comes back up... You never get a connect to it with a crossover
> cable.
> But I can access it via a wireless connection. The ethernet port is
enabled
> but still no go. I have verified that the crossover cable it good..
>
> Has anyone else seen this problem??
> I can't figure out why the ethernet port is just dead.
>
> Nate
>
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
>
|