Bob,
Thanks for the reply but please see notes within:
---------- Original Message ----------------------------------
From: "Bob Hrbek" <bhrbek@jagwireless.com>
Reply-To: karlnet@WISPNotes.com
Date: Fri, 25 Oct 2002 13:24:37 -0500
>Here....I'll give you the skinny..
>
>power on your device (ap/rg)
>
>hit the reset button then hold down the forced reload button until JUST the
>power led is RED.
Done no problem
>
>Open the configurator program.
>Click on "file" then "open remote config". scan for the device. Highlight
>the device and change the IP to one within your ip subnet. Use "public" as
>the password. Click OK. the IP will be changed. Click "cancel" until you
>get back to the conf program.
>
Done, no problem
>click on "File" then "open config file". Choose the appropriate bin. Find
>the license key for the devices mac.
>
>Don't do anything else. Click on "file" and "Upload software".
Done, so far so good.
Scan for
>the device again, highlight the correct device and use "public" for the
>password.
Cant find the device. I turn around and all red leds again. I have to put it
back into forced reload again. WHAT GIVES?
>The software will load and the device will reboot.
>
>It sounds harder than it is.
>
>-bob
>----- Original Message -----
Thanks for any help,
--
Eric L. Johnson
WarpSpeed Internet
1-361-563-3742
--
|