Are you sure you have the correct MAC? It is the MAC of the Ethernet not
the wireless..
----- Original Message -----
From: "admin " <admin@mail.warpspeedinternet.ws>
To: <karlnet@WISPNotes.com>
Sent: Friday, October 25, 2002 1:48 PM
Subject: Re: [Karlnet] reloading BIN file procedure
> Bob,
> Thanks for the reply but please see notes within:
>
> ---------- Original Message ----------------------------------
> From: "Bob Hrbek" <bhrbek@jagwireless.com>
> Reply-To: karlnet@WISPNotes.com
> Date: Fri, 25 Oct 2002 13:24:37 -0500
>
> >Here....I'll give you the skinny..
> >
> >power on your device (ap/rg)
> >
> >hit the reset button then hold down the forced reload button until JUST
the
> >power led is RED.
>
> Done no problem
> >
> >Open the configurator program.
> >Click on "file" then "open remote config". scan for the device.
Highlight
> >the device and change the IP to one within your ip subnet. Use "public"
as
> >the password. Click OK. the IP will be changed. Click "cancel" until
you
> >get back to the conf program.
> >
>
> Done, no problem
>
> >click on "File" then "open config file". Choose the appropriate bin.
Find
> >the license key for the devices mac.
> >
> >Don't do anything else. Click on "file" and "Upload software".
>
> Done, so far so good.
>
> Scan for
> >the device again, highlight the correct device and use "public" for the
> >password.
>
> Cant find the device. I turn around and all red leds again. I have to put
it back into forced reload again. WHAT GIVES?
>
>
> >The software will load and the device will reboot.
> >
> >It sounds harder than it is.
> >
> >-bob
> >----- Original Message -----
> Thanks for any help,
>
>
> --
> Eric L. Johnson
> WarpSpeed Internet
> 1-361-563-3742
> --
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
>
|