The only time I have had that problem was when I licensed a incorrect MAC
Address.
Nate
-----Original Message-----
From: karlnet-admin@WISPNotes.com [mailto:karlnet-admin@WISPNotes.com]On
Behalf Of admin
Sent: Friday, October 25, 2002 3:28 PM
To: karlnet@WISPNotes.com
Subject: Re: [Karlnet] reloading BIN file procedure
It is the mac that shows up in the scan.
---------- Original Message ----------------------------------
From: "Bob Hrbek" <bhrbek@jagwireless.com>
Reply-To: karlnet@WISPNotes.com
Date: Fri, 25 Oct 2002 14:18:43 -0500
>Are you sure you have the correct MAC? It is the MAC of the Ethernet not
>the wireless..
>
>
>----- Original Message -----
>From: "admin " <admin@mail.warpspeedinternet.ws>
>To: <karlnet@WISPNotes.com>
>Sent: Friday, October 25, 2002 1:48 PM
>Subject: Re: [Karlnet] reloading BIN file procedure
>
>
>> Bob,
>> Thanks for the reply but please see notes within:
>>
>> ---------- Original Message ----------------------------------
>> From: "Bob Hrbek" <bhrbek@jagwireless.com>
>> Reply-To: karlnet@WISPNotes.com
>> Date: Fri, 25 Oct 2002 13:24:37 -0500
>>
>> >Here....I'll give you the skinny..
>> >
>> >power on your device (ap/rg)
>> >
>> >hit the reset button then hold down the forced reload button until JUST
>the
>> >power led is RED.
>>
>> Done no problem
>> >
>> >Open the configurator program.
>> >Click on "file" then "open remote config". scan for the device.
>Highlight
>> >the device and change the IP to one within your ip subnet. Use "public"
>as
>> >the password. Click OK. the IP will be changed. Click "cancel" until
>you
>> >get back to the conf program.
>> >
>>
>> Done, no problem
>>
>> >click on "File" then "open config file". Choose the appropriate bin.
>Find
>> >the license key for the devices mac.
>> >
>> >Don't do anything else. Click on "file" and "Upload software".
>>
>> Done, so far so good.
>>
>> Scan for
>> >the device again, highlight the correct device and use "public" for the
>> >password.
>>
>> Cant find the device. I turn around and all red leds again. I have to put
>it back into forced reload again. WHAT GIVES?
>>
>>
>> >The software will load and the device will reboot.
>> >
>> >It sounds harder than it is.
>> >
>> >-bob
>> >----- Original Message -----
>> Thanks for any help,
>>
>>
>> --
>> Eric L. Johnson
>> WarpSpeed Internet
>> 1-361-563-3742
>> --
>> _______________________________________________
>> Karlnet mailing list
>> Karlnet@WISPNotes.com
>> http://lists.wispnotes.com/mailman/listinfo/karlnet
>>
>
>_______________________________________________
>Karlnet mailing list
>Karlnet@WISPNotes.com
>http://lists.wispnotes.com/mailman/listinfo/karlnet
>
--
Eric L. Johnson
WarpSpeed Internet
1-361-563-3742
--
_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet
|