Karlnet
[Top] [All Lists]

Re: [Karlnet] KN Throughput

To: karlnet@WISPNotes.com
Subject: Re: [Karlnet] KN Throughput
From: Roger Boggs <rogerboggs@att.net>
Reply-to: karlnet@WISPNotes.com
Date: Tue, 12 Nov 2002 22:21:04 -0500
List-post: <mailto:karlnet@WISPNotes.com>
In "clean air", you should expect about 5.5Mbps maximum out of this configuration

As Charles said, use a flashrom module on a 300MHz or better machine and you
should expect to see about 6.7Mbps or better, depending on the equipment you're using



At 09:06 PM 11/12/02, you wrote:
Ap-1000 -> Ap-1000....what should it be?

say a 5 mile link, no polling, and say...an SNR on each side of 25 and a
signal of -65dbm at each side.  (unamped)


----- Original Message ----- From: "Kevin Knuth" <kknuth@karlnet.com> To: <karlnet@WISPNotes.com> Sent: Tuesday, November 12, 2002 8:00 PM Subject: RE: [Karlnet] KN Throughput


> All, > > The actual throuhput is affected by the hardware as well. > > An RG has a slower processor than an AP-1000 so it will be a bit slower. > Processor speed is important because of unbundling the superframe packets. > > SO- What hardware are you using exactly??( Charles's question from earlier, > he was on the right track). > > Kevin > ____________________________________ > Kevin R. Knuth > Business Development Manager > North America > Corporate Office: 614-822-5275 x130 > Home Office: 260-424-9690 > Cell Phone: 260-402-6086 > Email: kknuth@karlnet.com > www.karlnet.com > ____________________________________ > > > -----Original Message----- > From: karlnet-admin@WISPNotes.com [mailto:karlnet-admin@WISPNotes.com]On > Behalf Of Bob Hrbek > Sent: Tuesday, November 12, 2002 8:42 PM > To: karlnet@WISPNotes.com > Subject: Re: [Karlnet] KN Throughput > > > I have a PtP karlnet link at the end of a 10 mile trango link. The Karlnet > link is about 5 miles and we get about 3.9Mbps but we have a "little" > frensel clearance issue ;) > > NOC--trango~~~~~~~~~~~~~~~~~~~~~KN~~~~~KN 15miles total; 3.9Mbps. The > best I've ever seen from any 802.11b stuff is 4.5Mbps and that was like a > 3/4 mile shot w/ 24dbi grids on each end. > > -bob > > > ----- Original Message ----- > From: "Nate McLain" <nate@ctrail.net> > To: <karlnet@WISPNotes.com> > Sent: Tuesday, November 12, 2002 7:32 PM > Subject: RE: [Karlnet] KN Throughput > > > > We have links that run 4-5mbps. > > > > Nate > > > > > > -----Original Message----- > > From: karlnet-admin@WISPNotes.com [mailto:karlnet-admin@WISPNotes.com]On > > Behalf Of John Maxwell > > Sent: Tuesday, November 12, 2002 7:26 PM > > To: karlnet@WISPNotes.com > > Subject: [Karlnet] KN Throughput > > > > > > Anyone out there know the actual throughput that we can get on a KN TC PtP > > link? To this point, I've only seen about 2mbps at the most. I > understood > > that they could do about 5-6mbps. > > > > Any words of wisdom? > > > > _______________________________________________ > > Karlnet mailing list > > Karlnet@WISPNotes.com > > http://lists.wispnotes.com/mailman/listinfo/karlnet > > > > > > > > _______________________________________________ > > Karlnet mailing list > > Karlnet@WISPNotes.com > > http://lists.wispnotes.com/mailman/listinfo/karlnet > > > > _______________________________________________ > Karlnet mailing list > Karlnet@WISPNotes.com > http://lists.wispnotes.com/mailman/listinfo/karlnet > > _______________________________________________ > Karlnet mailing list > Karlnet@WISPNotes.com > http://lists.wispnotes.com/mailman/listinfo/karlnet >

_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet

Roger Boggs




<Prev in Thread] Current Thread [Next in Thread>