Caleb,
I am just wondering if you have personally confirmed that the updated
firmware allows the link test to work?
Dan Metcalf
Wireless Broadband Systems
http://www.wbsysnet.com/
781-577-2780
dan.metcalf@wbsysnet.com
> -----Original Message-----
> From: karlnet-bounces@WISPNotes.com
[mailto:karlnet-bounces@WISPNotes.com]
> On Behalf Of Caleb Carroll
> Sent: Friday, March 28, 2003 7:24 PM
> To: Karlnet Mailing List
> Subject: RE: [Karlnet] WPBASE+ with SENAO 200mw radio cards
>
> Yes, you can see signal values on both sides of the link if you start
the
> test from the BaseStation (you only see one side with signal values if
you
> start the link test from the client side).
>
> Additionally: You need to update your cards with the latest Prism 2.5
> firmware to be able to see both sides of the link test from the base
> station. see previous list messages for where to download firmware.
Also
> see previous emails regarding heat...
>
> *********** REPLY SEPARATOR ***********
>
> On 2003-Mar-28 at 6:21 PM Dan Metcalf wrote:
>
> >The senao cards I have used seem to over heat and RX became a
> >problem.... are you able read the signal's?
> >
> >Dan Metcalf
> >Wireless Broadband Systems
> >http://www.wbsysnet.com/
> >781-577-2780
> >dan.metcalf@wbsysnet.com
> >
> >
> >> -----Original Message-----
> >> From: karlnet-bounces@WISPNotes.com
> >[mailto:karlnet-bounces@WISPNotes.com]
> >> On Behalf Of Caleb Carroll
> >> Sent: Friday, March 28, 2003 4:27 PM
> >> To: Karlnet Mailing List
> >> Subject: RE: [Karlnet] WPBASE+ with SENAO 200mw radio cards
> >>
> >> These cards are all pretty much identical and Zcomax cards are just
> >> expensive. We have a shitload of EnGenius cards (re-branded Senao)
> >and
> >> they've been working fine for months (as long as you're using
> >TurboCell
> >> and not 802.11b of course).
> >>
> >> We're using the EnGenius cards with RG-1100's and AP-1000's though,
so
> >I
> >> can't help Don with this problem but somehow I doubt that the
problem
> >is
> >> with the Senao cards.
> >>
> >> *********** REPLY SEPARATOR ***********
> >>
> >> On 2003-Mar-28 at 10:14 AM Charles Chia Sheng Wu wrote:
> >>
> >> >Senao cards are crap, use the Zcomax cards
> >> >
> >> >-Charles
> >> >
> >> >-----Original Message-----
> >> >From: karlnet-bounces@WISPNotes.com
> >> >[mailto:karlnet-bounces@WISPNotes.com]On Behalf Of Don Starnes
> >> >Sent: Friday, March 28, 2003 9:57 AM
> >> >To: Karlnet
> >> >Subject: [Karlnet] WPBASE+ with SENAO 200mw radio cards
> >> >
> >> >
> >> >Hello everyone,
> >> >
> >> >I am having a hard time trying to get the new WPBASE+ to work with
> >SENAO
> >> >200mw (Intersil 2.5) or 100mw (Intersil 2.0) radio cards. The
board
> >> >recognizes the radios and will let you program them as usual. The
> >> problem
> >> >seems to occur after they have been in service for a few hours. I
> >get
> >> very
> >> >erratic behavior from the boards such as:
> >> >1. Second radio stops working
> >> >2. Second radio disappears
> >> >3. Port shows empty PCMCIA when I know there is a card in it.
> >> >
> >> >I know everyone's setup can be different. We are using 12v 10a
power
> >> >supplies to power these boards. We have version 4.43a bin file on
> >the
> >> >radios.
> >> >
> >> >Any suggestions?
> >> >
> >> >Thank You,
> >> >
> >> >Don
> >> >
> >> >
> >> >_______________________________________________
> >> >Karlnet mailing list
> >> >Karlnet@WISPNotes.com
> >> >http://lists.wispnotes.com/mailman/listinfo/karlnet
> >> >
> >> >_______________________________________________
> >> >Karlnet mailing list
> >> >Karlnet@WISPNotes.com
> >> >http://lists.wispnotes.com/mailman/listinfo/karlnet
> >>
> >>
> >>
> >>
> >> _______________________________________________
> >> Karlnet mailing list
> >> Karlnet@WISPNotes.com
> >> http://lists.wispnotes.com/mailman/listinfo/karlnet
> >> ---
> >> [This E-mail scanned for viruses by Declude Virus]
> >
> >
> >---
> >[This E-mail scanned for viruses by Declude Virus]
> >
> >_______________________________________________
> >Karlnet mailing list
> >Karlnet@WISPNotes.com
> >http://lists.wispnotes.com/mailman/listinfo/karlnet
>
>
>
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
> ---
> [This E-mail scanned for viruses by Declude Virus]
---
[This E-mail scanned for viruses by Declude Virus]
|