We had the same problem with "4.31a". We went to 4.31 and it worked through
radio port.
----- Original Message -----
From: "Robert Farrar" <robert@secnet.com.au>
To: <karlnet@WISPNotes.com>
Sent: Sunday, May 18, 2003 10:35 AM
Subject: [Karlnet] AP-1000 Ethernet port stuffed ?
> I have an AP-1000 flashed with v4.31 firmware & I can not seem to access
the
> unit via the ethernet port. I have tried reflashing the unit but it will
not
> let me at the ethernet port.
>
> I have managed to access via ndis connection and have changed to other
> ethernet port speeds etc, but it still will not work via that port.
>
> Does anyone have any ideas on what else I could try, if not then could the
> ethernet port be faulty, can they be repaired or is it possible to get the
> license transfered to another MAC address on another unit that does
> acctually work ?
>
> Regards,
>
> Robert Farrar
> Australia
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
|