I have an Orion 565 with firmware 3.032x5. When I select mode UCW or LCW
the txcvr immediately goes into tx and transmits a continuous carrier and
locks in this mode until I change back to USB or LSB.
If the rig in in USB or LSB as soon as I use the tuner the rig locks again.
I seem to recall this started after I inadvertently pressed User1 or User2
when keying in UCW (but I’m not 100% sure) I have tried a Master Reset
and also reloading the firmware buit this doesn’t fix the problem. Any
bright ideas out there please?
73 Dick ZS6BUN
Dick Coates
*MBT South Africa*
*Distributors of Plastics Raw Materials*
Office: +27 11 4552889
Fax: +27 11 4552937
Cell: +27 82 6007398
www.mbtsa.co.za
_______________________________________________
Orion mailing list
Orion@contesting.com
http://lists.contesting.com/mailman/listinfo/orion
|