Orion
[Top] [All Lists]

Re: [Orion] Orion 565 locks in CW tx mode

To: Barry N1EU <n1eu.barry@gmail.com>, orion@contesting.com
Subject: Re: [Orion] Orion 565 locks in CW tx mode
From: Dick Coates <dick@mbtsa.co.za>
Date: Wed, 25 Mar 2015 15:39:15 +0200
List-post: <orion@contesting.com">mailto:orion@contesting.com>
Thanks Barry. I'm sure I've done that but I'll do it again just to make sure
!

Dick  ZS6BUN



-----Original Message-----
From: Orion [mailto:orion-bounces@contesting.com] On Behalf Of Barry N1EU
Sent: 25 March 2015 13:07 PM
To: orion@contesting.com
Subject: Re: [Orion] Orion 565 locks in CW tx mode

First thing I would do is unplug everything from the radio except antenna
and power.  Then check if it still behaves like that.

73, Barry N1EU

On Wed, Mar 25, 2015 at 3:00 AM, Dick Coates <dick@mbtsa.co.za> wrote:

> I have an Orion 565 with firmware 3.032x5. When I select mode UCW or
> LCW the txcvr immediately goes into tx and transmits a continuous
> carrier and locks in this mode until I change back to USB or LSB.
>
> If the rig in in USB or LSB  as soon as I use the tuner the rig locks
> again.
>
>
>
> I seem to recall this started after I inadvertently pressed User1 or
> User2  when keying in UCW (but I’m not 100% sure)  I have tried a
> Master Reset and also reloading the firmware buit this doesn’t fix the
> problem.  Any bright ideas out there please?
>
>
>
> 73  Dick  ZS6BUN
>
>
>
> Dick Coates
>
> *MBT South Africa*
>
> *Distributors of Plastics Raw Materials*
>
> Office: +27 11 4552889
>
> Fax:      +27 11 4552937
>
> Cell:      +27 82 6007398
>
> www.mbtsa.co.za
> _______________________________________________
> Orion mailing list
> Orion@contesting.com
> http://lists.contesting.com/mailman/listinfo/orion
>
_______________________________________________
Orion mailing list
Orion@contesting.com
http://lists.contesting.com/mailman/listinfo/orion
_______________________________________________
Orion mailing list
Orion@contesting.com
http://lists.contesting.com/mailman/listinfo/orion
<Prev in Thread] Current Thread [Next in Thread>