Golly that gets complicated!
My rusty old Kenwood is in split, both VFOs on FSK normal. MMTTY is set to
Reverse, for the decode, but that does the job here.
73,
Gert - K5WW
> From: George Johnson <w1zt@comcast.net>
> Subject: Re: [RTTY] The other guy's TX is reversed
> To: K4FJ@aol.com, RTTY@contesting.com
> Message-ID: <5.2.1.1.0.20060726195342.03398e70@mail.comcast.net>
> Content-Type: text/plain; charset=us-ascii; format=flowed;
> x-avg-checked=avg-ok-59842985
>
> Steve,
> Yes, this happens. I was successful with the following approach.
>
> I use a 756PRO2 and can split between 2 VFOs. And each VFO can be set to
> any "mode". and I use that nasty AFSK which I quite like... Sooo...
>
> 1. RTTY decoder (RITTY by K6STI) is set to "Normal"
> 2. VFO A is set to USB so I can copy him "reversed"
> 3. VFO B is set to LSB so I can transmit "normal"
> I only use one "window" to receive with this program.
>
> I have the option of screwing around with the mode on VFO B to reverse my
> tones if I think it might help. YU6AO was receiving me just fine in
> "normal" tone order.
> Just another approach. You can do the same using "FSK" if you can
> independently set mode on each VFO. Some rigs have a FSK-R setting also.
> 73 and good luck,
> George .. W1ZT
>
>
> At 07:31 PM 7/26/2006, K4FJ@aol.com wrote:
>
>>OK, here is the problem. The dxpedition comes on RTTY and is
>>transmitting
>>reversed but receiving normal.
>>
>>I use WriteLog and RttyRite, and it is a pain to handle that situation.
>>My
>>old HAL software allowed me to select rx and tx polarity.
>>
>>So how are the Big Guys doing it?--better than me, I hope.
>>
>>73, Steve
>>
>>_______________________________________________
>>RTTY mailing list
>>RTTY@contesting.com
>>http://lists.contesting.com/mailman/listinfo/rtty
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|