RTTY
[Top] [All Lists]

Re: [RTTY] bandpass filters

To: Jeff AC0C <keepwalking188@ac0c.com>, Bill Turner <dezrat@outlook.com>, RTTY Reflector <rtty@contesting.com>
Subject: Re: [RTTY] bandpass filters
From: Al Kozakiewicz <akozak@hourglass.com>
Date: Sun, 20 Mar 2016 14:01:21 +0000
List-post: <rtty@contesting.com">mailto:rtty@contesting.com>
Well duh.  Instead of drinking this coffee, I'll pour it on my crotch to wake 
up.

Al
AB2ZY

-----Original Message-----
From: Jeff AC0C [mailto:keepwalking188@ac0c.com] 
Sent: Sunday, March 20, 2016 9:43 AM
To: Al Kozakiewicz; Bill Turner; RTTY Reflector
Subject: Re: [RTTY] bandpass filters

To suppress harmonic content that is generated by the amps.

73/jeff/ac0c
www.ac0c.com
alpha-charlie-zero-charlie

-----Original Message-----
From: Al Kozakiewicz
Sent: Sunday, March 20, 2016 8:25 AM
To: Bill Turner ; RTTY Reflector
Subject: Re: [RTTY] bandpass filters

Since the highest power transceivers are 200 watts, why would you need filters 
rated for 1500? There is no technical reason I can think of why they can't go 
between the xcvr and amp.

Al
AB2ZY

-----Original Message-----
From: RTTY [mailto:rtty-bounces@contesting.com] On Behalf Of Bill Turner
Sent: Saturday, March 19, 2016 11:15 PM
To: RTTY Reflector
Subject: Re: [RTTY] bandpass filters

Bandpass filters at the 1500 watt level are quite expensive - around
$400 for each band. Do the math.

If you want to save some money, you can build your own.  Accompanying each ARRL 
Handbook is a CD which contains design software for high pass and low pass 
filters. By choosing the cutoff frequencies carefully and putting them in 
series, you could save a considerable amount of money.

This particular software is especially useful because it uses standard value 
components. In fact that is the name of the program: SVC Filter Designer. 
Here's a hint: Each filter segment can be looked at as a parallel resonant 
circuit, i.e. a coil paralleled by two capacitors in series. You can use a grid 
dip meter to carefully adjust the coil to resonate at the frequency given by 
the standard equations for resonance. Do each filter segment separately, then 
connect them together. You can check the final result by sweeping it with an 
SWR meter while terminated into a dummy load or a real antenna.

It is also available at this website:  http://tonnesoftware.com/ along with 
other filter design software and there may be others as well. It is well worth 
browsing around.

73, Bill W6WRT
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty 

_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty

<Prev in Thread] Current Thread [Next in Thread>