Thanks Tim,
I guess I phrased my statement in a misleading way. When I say I shut
everything down, the PC was not part of that. I only shut down N1MM+ and
the radio. So the ports did not change.
I have checked and everything is still configured to use the correct audio
sources over the USB cable.
73,
Mike ND9G
On Sun, Jul 16, 2017 at 8:56 AM, Tim Shoppa <tshoppa@gmail.com> wrote:
> ND9G writes:
> > I needed to take a break for dinner, so shut everything down for an hour.
> > When I came back and started everything up again, all 3 of the decoders
> on
> > my PC had trouble decoding anything. They would get some decoded, then
> just
> > stop decoding. Then they would start back to decoding again. This
> happened
> >on pretty much every QSO after the break.
>
> Windows 7 and Windows 10 can arbitrarily rename/reconnect audio devices if
> you unplug some audio device or plug a new audio device in, and can also
> just reconnect things differently after a reboot.
>
> What I have found happening, is that a microphone hooked to the computer
> gets mistakenly gets selected as the audio input to the RTTY decoders,
> instead of the rigs audio output hooked to PC's Line In. This can be very
> frustrating because just enough audio leaks out of the headphones and into
> the computer microphone that it shows on the waterfall and kinda sorta
> decodes but not well.
>
> Tim N3QE
>
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|