Yes, V18.21 is 18 months old, and there's been many
changes in the meantime, including some of the code
relating to WinKey.
SD V19.22 works reliably with original WinKey units.
With WinKey clones, some experimentation with
parameters may be needed.
Please try these commands
CWDTRON & CWDTROFF - toggle DTR on the CW port
CWRTSON & CWRTSOFF - toggle RTS on the CW port
The default is OFF for both DTR and RTS as they
are not needed by WinKey, but one (or both) may
be needed for WinKey clones.
In any case, it's clear that I need to integrate
these functions into the SETUP command for WinKey.
73,
Paul EI5DI
On 04/12/2017 19:58, Alister Watt wrote:
Hi Paul,
Has anything changed on the CW port software since V18.21? The last
versions I have tried, V19.21b and V19.22 do not reliably detect my
Winkeyer clone. It beeps as if the power or a reset command is sent on
initialise, and SD doesn't print Winkey V23 detected.
I have tried using V18.21's SD.INI file and an ini file from Bryn
without success.
73,
Al
_______________________________________________
SD-User mailing list
SD-User@contesting.com
http://lists.contesting.com/mailman/listinfo/sd-user
|