TenTec
[Top] [All Lists]

[TenTec] Broad Band Antenna

To: <tentec@contesting.com>
Subject: [TenTec] Broad Band Antenna
From: RMcGraw@InfoAve.Net (Bob & Linda McGraw K4TAX)
Date: Sun, 28 Jan 2001 20:31:42 -0800
I'd like to know the value of the R which is opposite the feedpoint in
the T2FD antenna.

Thanks in advance.

73
Bob K4TAX

Bwana Bob wrote:
> 
> Yes, it was the MAXCOM antenna that had the scrap pieces of pc board
> inside the feed point, in addition to the loading resistors. The MAXCOM
> had the loading resistors located at the feedpoint, as the ARRL test
> confirmed, the swr was low even with no wires connected to it!
> 
> The B&W is a true T2FD, which is a floded dipole with the resistive
> loading located opposite the feedpoint. I saw some specs but I don't
> recall whether they were for the B&W or the Telex version. The
> manufacturer was honest enough to list efficiency, and as, expected,
> efficiency at 3.5 MHz was about 40%.
> 
> The only advantage of these antennas is for disaster releif agencies
> who have nontechnical operators and need "plug and play" operation, and
> the military who use frequency hopping tecniques over a wide range of
> frequencies.
> 
> For amateurs, a dipole or loop and a tuner will provide much better
> performance. Every shack should have a tuner. It is a very easy beginner
> project and Ten-Tec sells the parts you need, as does Fair Radio Sales.
> 
>                         73,
> 
>                         Bob WB2VUF
> 
> --
> FAQ on WWW:               http://www.contesting.com/FAQ/tentec
> Submissions:              tentec@contesting.com
> Administrative requests:  tentec-REQUEST@contesting.com
> Problems:                 owner-tentec@contesting.com


--
FAQ on WWW:               http://www.contesting.com/FAQ/tentec
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com


<Prev in Thread] Current Thread [Next in Thread>