Add a 100 ohm resistor in the headphone plug in series with the common
headphone ground. This will desensitize the headphones enough to allow you
to run a higher audio gain and drown out the click.
Carl Moreschi N4PY
Franklinton, NC
----- Original Message -----
From: <K4IA@aol.com>
To: <tentec@contesting.com>
Sent: Friday, December 26, 2003 1:50 AM
Subject: [TenTec] Headphone clicks
> Just getting into my second day with the Orion and I notice a very
annoying
> key click in the headphones. It is mostly on the dits. Reducing power
down to
> 1 watt makes no difference. Setting the Sidetone volume lower does not
> reduce the clicks -- it just makes them more noticeable. I have tried
various
> combinations of right/left main/sub and BinRx but not much difference.
Might be
> more noticeable in the right headphone.
>
> Recycling the power off does not help. Neither did a master Reset. Using
> the latest firmware download.
>
> Comments?
>
> Radio k4ia
> Craig "Buck"
> Fredericksburg, Virginia USA
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|